Gas Detection

Polytron FX

The Polytron FX is an explosion proof gas detector for continuous monitoring of combustible gases and vapors in ambient air.

The transmitter uses industry standard three-wire analog technology, and converts the signal from a catalytic combustion DrägerSensor to a 4 to 20 mA signal that is proportional to the actual gas concentration.

The unit is designed for one-man calibration and easy to operate.

Pointgard II

The Pointgard II is a microprocessor controlled, stand alone gas detector for continuous monitoring of toxic gases and oxygen in ambient air

Gas concentration is seen on a large display, while the horn and two strobes provide alarm annunciation on the outside of the enclosure. Alarms at the point of exposure ensure a speedy response to any gas leaks and quick evacuation when necessary

The stand alone monitor can be configured for H2S, CO, O2,NH3, Cl2, NO2, SO2, H2O2 and ethylene oxide. Change any of the set up details easily using the short menu guide.

Drager X-am 3000

Dräger X-am 3000 is an innovative 3- or 4 gas warning-device. This small and lightweight instrument reliably monitors H2S, CO, O2 and combustible gases and vapors in ambient air

A large display enables the easy identification of the measured values. The simple 3-button operation and an easy to use menu ensure intuitive operation.

Our precalibrated electrochemical sensors, and the catalytic sensor are automatically recognized and provide precise and reliable measuring results.

In addition to a very loud audible alarm and a bright visual alarm, a vibrating alarm is integrated in the instrument.

A life signal assures full functionality of the instrument without a visual check by the operator. Even if the peak value disappeared before it could get registered, the Dräger X-am 3000 can recall all maximum values. When using a defined gas mixture, the instrument can be calibrated by pressing a single button.

An optional internal pump with a 10 m (33 ft.) tubing is ideal for confined space applications. A convenient pump adaptor makes is easy to switch between pump and diffusion modes.

Its compact design combined with state of the art electronics ensures that it is ideally suited for gas detection requirements in all applications and industries